A SERVICE OF

logo

Open as PDF
next previous
EN
24
dirty.
• Closethetaps.
• Removethenutsofthewaterintake
hoses to clean the surfaces of the
filters on the water intake valves with
an appropriate brush.
• Ifthefiltersareverydirty,youcan
pull them out by means of pliers and
clean them.
• Takeoutthefiltersontheflat
ends of the water intake hoses
together with the gaskets and clean
thoroughly under streaming water.
• Replacethegasketsandfilters
carefully and tighten the hose nuts
by hand.
Draining any remaining water
and cleaning the pump filter
Filter system in your machine prevents
solid items such as buttons, coins and
fabric fibers clogging the pump propeller
during discharging of the washing water.
• Ifyourmachinefailstodrainthe
water, the pump filter may be
clogged.Youmayhavetoclean
it every 2 years or whenever it is
blocked plugged. Water must be
drained off to clean the pump filter.
In addition, water may have to be
drained off completely in the following
cases:
• beforetransportingthemachine
(e.g.whenmovinghouse)
• whenthereisthedangeroffrost
In order to clean the dirty filter and
dischargethewater;
1- Disconnect or unplug the machine
from the power supply.
A
There may be water at 90°C in the
machine. Therefore, the filter must
be cleaned only after the inside
water is cooled down to avoid
hazard of scalding.
2-Openthefiltercap.Thefiltercap
may be composed of one or two pieces
according to the model of your machine.
If it is composed of two pieces, press
the tab on the filter cap downwards and
pull the piece out towards yourself.
If it is composed of one piece, hold it
from both sides and open it by pulling
out.
3- An emergency drain hose is supplied
withsomeofourmodels.Othersarenot
supplied with this item.
If your product is supplied with an
emergency drain hose, do the following
asshowninthefigurebelow: