Baracoda DualRunners – User Guide v1.7 - 14 -
Data Capture
for Workforce
in Motion
6.5.7 Data Identifier
The DualRunners allows to identify the nature of the data scanned/readed: RFID or Barcode.
This option is the “DATA NATURE BYTE”. When it enables, an identifier number is added before the data:
- “0” for a barcode data
- “1” for a RFID data.
You can enable this option through BaracodaManager software (v3.36 min) or with the Programming Guide.
By default, the DATA NATURE BYTE” option is disabled.
6. 6 Beeps and LEDs
You can enable/disable Beeps / LED Lightening using both the BaracodaManager software (v3.36 min) or the
Programming Guide.
6.7 Power management
Mutliple parameters exist to optimize the battery autonomy (“Sniff period”, “Shutdown timer”, etc…)
DualRunners is configured at 20dBm (Bluetooth Class.1) by default.
The BaracodaManager software (v3.36 min) can be used for multiple setting changes.
6.8 Low battery
An alternation of red and green blinking on the two (2) LEDs indicates that the battery level is low. Recharge
battery immediately. If you continue using the scanner, it will continue working until a triple beep occurs: at
that moment the reader will shut down and you will be forced to charge the scanner.
