Audiovox LCMR4N Manual

next previous

1. Installation Instructions

1) Mount the mirror/monitor onto the existing rearview mirror.

a) Stick two adhesive foam backings on to the back of mirror in the two small

rectangle indents.

b) Take the two seven inch belts and slide them into the slots on the top rear of

the mirror with grooved side of the belt facing down.

Figure 1

c) Take the buckles and slide them into the lower slots on the rear of the mirror

with the buckle facing toward the seven-inch belt.

Figure 2

NOTE: The large opened rectangle on the buckle will face away from the

seven-inch strap.

d) Mount the new rearview mirror/monitor onto the existing one. Add the

rearview mirror onto the existing mirror from one side with one fixed belt.

Then fasten the other belt on the other side of the mirror. To prevent the

LCMR4N from falling off, tighten the belts until secure to the factory rearview

mirror on both sides.