UV Light
Operation
Before leak checking with the UV light:
(a.) Make sure the A/C system is properly charged with
sufficient dye. (See manufacturer’s specifications for
proper dye charge.)
(b.) Run the A/C system long enough to thoroughly mix and
circulate the dye with the refrigerant and lubricating oil.
1. Turn on UV light by pressing the UV light ON/OFF button. (See
control panel on page 2)
2. Holding the leak detector approximately 10” to 14” away, shine the
UV light beam slowly over the components, hoses, and metal lines
that make up the A/C system.
3. When the UV light shines on the fluorescent dye that has escaped
from the system, the dye will glow a bright yellow green.
3 UV LED’s
3
Replacement Parts
Item Part Number
Sensor with Filter PRT3700-01
Sensor filters (5 pack) PRT3700-02
Leak Test Vial PRT3700-03
Carrying Case PRT3699-CASE
RETURN FOR REPAIR POLICY
Every effort has been made to provide reliable, superior quality
products. However, in the event your instrument requires repair,
forward unit to Service Center freight prepaid to the address below
with return address, phone number and/or email address.
SERVICE CENTER
2651 W 81st Street
Hialeah, FL 33016
WARRANTY POLICY
The ATD-36750 Refrigerant Gas Leak Detector is warranted to be
free of defects in materials and workmanship for a period of two
years from the date of purchase. This warranty applies to all
repairable instruments that have not been tampered with or
damaged through improper use including unauthorized opening of
the unit. Please ship warranty units that require repair freight
prepaid to Service Center along with proof of purchase, return
address, phone number and/or email address.
7
