SERVICE
1. Tool service must be performed only
by qualified repair personnel. Service
or maintenance performed by
unqualified personnel could result in a
risk of injury.
2. When servicing a tool, use only
identical replacement parts. Follow
instructions in the Maintenance section
of this manual. Use of unauthorized
parts or failure to follow Maintenance
instructions may create a risk of electric
shock or injury.
SPECIFIC SAFETY
RULES
1. Accessories must be rated for at least
the speed recommended on the tool
warning label. Wheels and other
accessories running over rated speed
can fly apart and cause injury.
2. Hold tool by insulated gripping surfaces
when performing an operation where
the polishing tool may contact hidden
wiring or its own cord. Contact with a
“live” wire will make exposed metal
parts of the tool “live” and shock the
operator.
GETTING STARTED
Before operating your ATD-10511 7"
Variable Speed Polisher, please check
the contents of the box to make sure you
have everything you will need.
ACCESSORIES:
Straight Auxiliary handle 1 pc
D-shape Auxiliary handle 1 pc
Spanner
1 pc
Carbon Brush
1set
Hex key wrench
1 pc
Rubber pad
1 pc
Velcro pad
1 pc
Wool bonnet 1 pc
ASSEMBLY
1. Choose the most comfortable position
for your side mount handle. Screw the
handle securely into one of the two
handle ports located at the base of the
gear housing.
2. Make sure tool is unplugged and lay it
on its back with the spindle upright.
3. Line up the notches on the inner ring
of the rubber backing pad with the
notches on the spindle. Securely slide
rubber backing pad on to spindle.
4. Hand tighten spindle nut on to spindle
threading.
5. Push in spindle lock button (located
on the back side of the metal gear
housing) and simultaneously tighten
spindle nut with spanner wrench. Be
sure to tighten nut securely.
6. After securing spindle nut, stretch
polishing bonnet over the face of the
rubber backing pad so that the bonnet
wraps around the back of the pad.
7. Pull the fit adjusting string on the
inside lip of the bonnet taut until all
slack is removed and bonnet is snug
against backing pad.
8. Tuck the fit adjusting string back
inside bonnet so it will not interfere
with bonnet surface during polishing.
You are now ready to begin operation of
your Polisher.
3
