Note: BAS intergrators requiring .xif file need to contact their local sales
representative.
Other optional network variables are not supported.
Object details
Figure 10
LED meaning and function
Green Status LED
LED status Meaning/Function
LED is OFF continuously. • Normal condition
• Broken hardware
• No power
LED is ON. • Broken hardware
· • During the activation of the service pin
• The node is Applicationless
LED blinks 1second then always OFF • When receiving a WINK command from the network (1)
LED blinks ½ second ON then always OFF • Normal operation (usually after a reset)
LED flashes once every second • The node card is not configured
• The node card is in continuous reset
(1) By sending a request, you can request the controller’s green status LED to blink (“wink”), a notification that the controller received the signal and is
communicating.
Red Service LED
LED status Meaning/Function
LED is ON for 20 seconds when power is applied to the controller • The controller is in a reset phase
LED is OFF continuously • The controller is operating normally
• Broken hardware
LED is ON during 2 seconds then always OFF • When power is applied to the controller
• After a reset
LED is ON continuously • The controller is not working properly
• Broken hardware
• Problems of connection with the CH532 module
26 CG-SV01B-E4
