© 2004 Alamo Group Inc.
Page 8 - 7
Interstater (NH TS-100A , 115A , 125A & 135A Asy. Manual) 06/04
CAUTION ROTATING KNIVES! Remove all foreign objects and stand clear of
cutter units. DO NOT GET NEAR!
NOTE: On tractor hydraulic powered circuit only, make certain that there is full flow from tractor
hydraulic system to control valve. Refer to tractor manual.
9. After hydraulic system is fully charged and functioning properly, switch cutter units on, then
speed engine up to 540 RPM PTO speed. Maintain this speed for about 5 minutes. Check
complete INTERSTATER, look for any leaks,loose connections, or anything that could cause
premature wear or failure.
FINAL CHECK
Run INTERSTATER for about 1/2 hour at full speed. Check for leaks and vibrations. Frequently
check oil temperature. Make certain it does not exceed 180 deg.
NOTE: When raising wings, make certain there is no interference with mower, frame, cylinders or
tractor. Lift wings slowly.
CAUTION: DO NOT leave unit unattended, and COMPLY WITH ALL WARNING DECALS.
If unit starts to make unusual noise, stop unit and check oil level. Also check for frothy oil which
would indicate a leak on suction side of system.
Initial Start-Up Procedure
