36
While playing
The battery
charging stand and
the recorder become
hot during the
charging procedure.
• This is normal and poses no danger.
Symptom Cause/Remedy
An MD is not
played normally.
• Repeat play is selected.
, Press P MODE/ for 2 seconds or more to change back to the
normal play (page 18).
• Playback mode is changed.
, Press P MODE/ for 2 seconds or more to change back to the
normal play (page 18).
An MD is not
played from the
first track.
• Disc playing stopped before it came to the last track.
, Press NX/ENTER for 2 seconds or more to start playing.
• The disc information has been stored to the Playback Information
Memory.
, Erase the disc information from the Playback Information
Memory (page 28).
Playback sound
skips.
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a short track.
Sound has a lot of
static.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
Volume cannot be
turned up.
• EAR GUARD is on.
, Release EAR GUARD settings (page 27).
• The “USER” on “SOUND” settings are being applied.
, This is not malfuntion. When this setting is applied, the
maximum volume setting will be limited to a certain level to
prevent excessive loudness.
No sound comes
through the
headphones/
earphones.
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i.
• The plug is dirty.
, Clean the plug.
Symptom Cause/Solution
