6.6.1 Setting up Check-weighing while weighing
• Press [Limit]. It will show the current High Limit with the left most
digit flashing and the HI symbol on the left of the display.
• To select the digit to be changed press [Limit/Î] or [%/Í]. Use
[Tare/Ï] to increment the flashing digit. When the desired value
is shown press [Zero/Enter] to accept the value. If you want to
reset the value to zero, press the [Func/C] key to clear the value.
• After pressing [Zero/Enter] the display will then show the Low
Limit, the “LO” symbol will be on to the left side of the display.
Enter the low limit in the same way the high limit was entered.
• The limits are displayed in Kg.
• Pressing the [Zero/Enter] key will return the scale to weighing,
with the Check-weighing function enabled.
• When a weight is placed on the scale the arrows will show
whether the weight is above or below the limits and the beeper
will sound as described below.
BOTH LIMITS SET
The display will show OK and the beeper will sound
when the weight is between the limits.
LOW LIMIT SET
HIGH LIMIT is set to zero.
The display will show OK and the beeper will sound
when the weight is less than the Low Limit. Above
the Low Limit the display will show HI and the beeper
will be off.
HIGH LIMIT SET LOW LIMIT is set to zero.
The display will show LO and the beeper will be off
when the weight is less than the High Limit. Above
the High Limit the display will show OK and the
beeper will be on.
BOTH LIMITS SET
LOW IS SET
GREATER THAN
HIGH
The beeper will never sound and the display will show
LO if the weight is less that the Low Limit and HI if the
weight is greater than the Low Limit.
© Adam Equipment Company 2007
11
