Interface Commands
4-133
4
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 4.
Console#show interfaces switchport ethernet 1/4
Broadcast Threshold: Enabled, 1042 packets/second
LACP Status: Disabled
Ingress Rate Limit: Disabled, 10000M bits per second
Egress Rate Limit: Disabled, 10000M bits per second
VLAN Membership Mode: Hybrid
Ingress Rule: Disabled
Acceptable Frame Type: All frames
Native VLAN: 1
Priority for Untagged Traffic: 0
GVRP Status: Disabled
Allowed VLAN: 1(u),
Forbidden VLAN:
Console#
Table 4-45 show interfaces switchport - display description
Field Description
Broadcast threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page4-129).
LACP status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 4-139).
Ingress/Egress rate limit Shows if rate limiting is enabled, and the current rate limit (page 4-136).
VLAN membership mode Indicates membership mode as Trunk or Hybrid (page 4-171).
Ingress rule Shows if ingress filtering is enabled or disabled (page 4-172).
Acceptable frame type Shows if acceptable VLAN frames include all types or tagged frames only
(page 4-172).
Native VLAN Indicates the default Port VLAN ID (page 4-173).
Priority for untagged traffic Indicates the default priority for untagged frames (page 4-185).
GVRP status Shows if GARP VLAN Registration Protocol is enabled or disabled
(page 4-183).
Allowed VLAN Shows the VLANs this interface has joined, where “(u)” indicates untagged and
“(t)” indicates tagged (page 4-174).
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP
(page 4-175).
