Fast EtherHub 3500 System User’s Guide
4-26 Configuring the System
Configuring Repeater Ports
If you select the repeater port type (i.e., 1 through 12), the Port
Configuration Menu will open. This menu displays the ID and
stack position of the selected hub, and also allows you to
enable/disable any repeater port in the selected hub.
Port Configuration
Return to Previous Panel
Hub ID : 1 Position : 1
Port ID Name Type Admin Status Oper Status Link State Partition
1. 100BASE-TX ENABLED ENABLED DOWN NOT PART
2. 100BASE-TX ENABLED DISABLED DOWN NOT PART
3. 100BASE-TX ENABLED ENABLED DOWN NOT PART
4. 100BASE-TX ENABLED ENABLED DOWN NOT PART
5. 100BASE-TX ENABLED ENABLED DOWN NOT PART
6. 100BASE-TX ENABLED ENABLED DOWN NOT PART
7. 100BASE-TX ENABLED ENABLED DOWN NOT PART
8. 100BASE-TX ENABLED ENABLED DOWN NOT PART
9. 100BASE-TX ENABLED ENABLED DOWN NOT PART
10. Steve 100BASE-TX ENABLED ENABLED UP NOT PART
11. 100BASE-TX ENABLED ENABLED DOWN NOT PART
12. 100BASE-TX ENABLED ENABLED DOWN NOT PART
Return to previous panel.
Use arrow keys to move. <Enter> to confirm.
<Ctrl+T> to return to Main Menu.
Figure 4-15 Port Configuration Menu
Menu items are briefly described in the following table.
Hub identifier within the stack.
The physical position in the stack (as determined by its position from the top of the FlexBus chain).
Numeric identifier 1~12 or SEM (i.e., SmartExtender Module).
User-defined name for selected port.
Connection type for the repeater Ports 1~12 is 100BASE-TX.
1
Any port may be set by the operator to ENABLED or DISABLED.
1
Reflects the port’s actual status as ENABLED or DISABLED.
Indicates if the port has a valid connection to an external device.
Indicates if the port is partitioned
. (Refer to Partition/Disable Indicators in Chapter 5 for a more
detailed description of the reasons a port may be partitioned.)
1 - If the port is set to ENABLED by the administrator, but used as a backup port, Admin Status and Oper Status will differ.
Table 4.11 Port Configuration Menu
