Filter
Top Products
(HIGHEST AUDIO QUALITY)
Connect the RCA plugs from the TV or VCR
audio output into the LEFT
and RIGHT RCA
jacks on the TX238 Transmitter
3. Next, slide the
stereo/mono switch 2on the TX238 Transmitter
to the stereo “ ” position. Your transmitter is
now set for stereo operation.
®
8
STEP 3: SELECT STEREO OR MONO OPERATION
Compatible with:
RX237
-or-
RX238
STEREO OPERATION:
Note: Choose 1 of 3 transmitter setup options below and on
page 9. Verify receiver compatibility on left.
Important: If your system is packaged with the WIR RX239
(neckloop) Receiver, you must setup the WIR TX238
Transmitter to operate in 2.3 MHz
(mono) mode. See 2.3 MHz
(mono) instructions on page 9. The WIR RX239 (neckloop)
Receiver will NO
T work while the transmitter is in stereo or
2.8 MHz mode.
If your system is packaged with the WIR RX237 or WIR RX238
Receiver, you can choose to operate the WIR TX238 in stereo OR
mono (2.3 or 2.8 MHz) operation. For the highest quality, stereo is
the recommended
mode of operation.
S
TEP 2 (CONTINUED):
NOTE: Some televisions have FIXED output and others have
VARIABLE output. If available, FIXED output should be
selected. Consult your television manual for more information.
“Fixed” output means the volume on the television will not
change when the volume is increased, decreased, or muted.
“Variable” output means the volume on the television will
change when it is increased, decreased, or muted. If variable out-
put is the only output available on your television, we recom-
mend using the supplied TV microphone. See page 9 for TV
microphone instructions.