Filter
Top Products
3
Getting started
Headset charger installation
Install the headset charger as shown below.
Headset charger
Plug the small end of
the headset charger
power adapter into
the power jack of the
headset charger.
Plug the large end of the headset
charger power adapter into an
electrical outlet not controlled by a
wall switch.
Power on the headset
Power on the headset before use. Place the headset in the headset charger or
press and hold for two seconds. The light ashes three times in blue and you
hear three beeps when the headset is being powered on.
Headset charging
After installing the headset charger,
charge the headset in its charger. The
headset is fully charged after three
hours of continuous charging. If the
light does not turn on while
charging, you need to charge
the headset without interruption for at
least 15 minutes to give the headset
enough charge to use for a short
time. For best performance, keep the
headset in the headset charger when
not in use. See the table on page 17
for battery operating times.
If the headset will not be used for a long time, press and hold for two seconds to
power off the headset. The light ashes three times in red and you hear three beeps
when the headset is being powered off.
1. Place the tip of the headset
in the small cradle on the
headset charger.
2. The magnet holds
the top of the
headset in place.
The light turns
on when charging.