Filter
Top Products
10
Editing Parameters
The Graphite M25 features 19 controls which settings can be customized using the Graphite
M25 computer editor, which can be found on the Samson website (www.samsontech.com). The
following information outlines the available parameters for each control that can be adjusted.
Trigger Pads: Note
Note: Sets the MIDI note name that the Trigger Pad will transmit.
MIDI Channel: Sets the specific MIDI channel that the Trigger Pad will use to transmit note data.
Mode: Sets the behavior of the pad. If set to toggle, the pad acts like a switch, sending a note
on message when first pressed, and a note off message when pressed a second time. When set
to momentary, the pad sends a note on message when pressed down and a note off message
when the pad is released.
Trigger Pads: CC
Control Change: Sets the control change number that the Trigger Pad will transmit.
MIDI Channel: Sets the specific MIDI channel that the Trigger Pad will use to transmit control
change data.
Mode: Sets the behavior of the pad to either toggle or momentary.
Transport Controls
Control Change: Sets the control change number and name that the Transport Control button will
transmit.
MIDI Channel: Sets the specific MIDI channel that the Transport Control button will use to
transmit data.
Mode: Sets the behavior of the button to either toggle or momentary.
Assignable Knobs
Control Change: Sets the control change number and name that the knob will transmit.
MIDI Channel: Sets the specific MIDI channel that the knob will use to transmit data.
Master Encoder
Control Change: Sets the control change number that the Master Encoder will transmit.
MIDI Channel: Sets the specific MIDI channel that the Master Encoder will use to transmit data.
Modulation Strip
Control Change: Sets the control change number that the Modulation strip will transmit.
MIDI Channel: Sets the specific MIDI channel that the Modulation strip will use to transmit data.