Filter
Top Products
6
6
1. Switch off the power of the headphone before charging.
2. Note: Before using the IR headphone for the first time, please
ensure that the batteries are fully charged (for 16 hours). This
will guarantee a longer operating life for the batteries.
3. Connect the recharge cable located on the back of the
transmitter into the charge input of the headphone.
4. The charge indication Green LED on the headphone will light
to indicate that the batteries are charging.
5. The batteries are fully charged after charging for at least 16
hours. Do not charge the batteries longer than 24 hours as
this will reduce battery performance. After charging, discon-
nect the headphone from the recharge cable.
1. Place the transmitter unit so that the front of the IR transmitter
approximately faces the center of your listening area (see
figure 5 on page 7).
2. Because IR light travels in a straight line, place the transmitter
at the same height, or slightly higher than the reception height,
of the headphone.
3. High IR light content such as sunlight and bright indoor lighting
may degrade the audio signal and cause interference. If you
experience such problems, simply move the system to a darker
area away from the source of the bright light.
RECHARGING
POSITIONING OF IR TRANSMITTER
WHR120RS_IB 7/3/02 8:49 AM Page 6