Filter
Top Products
2
When using your Remote Control Signal Sender as with any other electri-
cal device, basic safety precautions should always be followed to reduce the
risk of fire, electric shock and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use
liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water, for example: near a bath tub,
washbowl, kitchen sink, or laundry tub, in a wet basement, or in or
near a swimming pool.
5. Do not place this product on an unstable cart, stand, or table.
The product may fall, causing serious damage to the product.
6. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of
power supply to your home or building, consult your dealer or local
power company.
7. To reduce the risk of electric shock, do not disassemble this product,
but take it to a qualified serviceperson when some service or repair
work is required. Opening or removing covers may expose you to dan-
gerous voltages or other risks and voids warranty. Incorrect reassembly
can cause electric shock when the product is subsequently used.
Operating Precautions
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK
NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
DBS_D940_IB.QXD 11/5/01 10:27 AM Page 2