Filter
Top Products
2
In the Controllers
1. Use a Phillips screwdriver to loosen
the battery compartment cover
screw. Then lift and remove the cov-
er.
2. Install the batteries in the compart-
ment as indicated by the polarity
symbols (+ and –) marked inside.
3. Replace the cover and tighten the
screw.
When the controller’s range decreases,
replace the batteries.
MOVING THE ROBOTS
To turn on a robot, slide
ON/OFF
on the
back of the robot to
ON
. The robot’s
eyes light, he says “Power up,” and an-
nounces his name. Then the four power
indicators on his chest light. Press the
reset button on the robot’s head to verify
that all four power indicators are on.
Use the red controller for the red robot
and the green controller for the green ro-
bot.
The controller’s buttons move the robot
as follows:
Forward
— Press both the left and right
forward control buttons together.
Backward
— Press both the left and
right backward control buttons together.
Left Turn
— Press the right forward
control button.
Right Turn
— Press the left forward
control button.
Rotate Clockwise
— Press both the left
forward and right backward control but-
tons together.
Rotate Counterclockwise
— Press
both the right forward and left backward
control buttons together.
Notes:
• Keep the robot within 15 to 20 feet
of the controller.
• Make sure there are no obstructions
between the robot and the control-
ler.
Left Control
Forward
Backward
Right Contol
Forward
Backward
60-1192.fm Page 2 Friday, July 9, 1999 3:27 PM