Filter
Top Products
INTRODUCTION
Congratulations on choosing the Gamester
Reflex Arcade Stick, the ultimate Dual Force
arcade stick officially licensed for the Xbox
video game system.
CONTENTS
1 x Arcade Pad
2 x Joysticks
1 x Instruction Manual
IMPORTANT
Before using this product, read the Xbox
Instruction Manual for safety, health and other
information.
PRODUCT FEATURES
1. Eight action buttons offering eight-bit analog
control (A, B, X, Y, R
T, LT, Black and White).
2. One program button (P
X) to activate two fully
programmable buttons (S
1 and S2).
3. Two vibration feedback motors, one for low
frequency forces, one for high frequency
forces.
4. Two interchangeable joysticks for maximum
comfort.
5. Two digital menu navigation buttons (Back
and Start).
6. One module expansion slot.
7. Xbox proprietary plug interface.
8. Inline Quick Release Connector.
9. Rubberized grip.
INLINE QUICK RELEASE CONNECTOR
The Inline Quick Release Connector is added to
help protect your Xbox game console
investment. It is designed to disconnect your
arcade stick from your console in the event that
the controller is pulled upon with an
unreasonable force.
During normal use, the Inline Quick Release
Connector should always remain connected.
Always use the console
connector to disconnect
your arcade stick
from the
console.
PROGRAMMABLE BUTTONS
Perform complex moves with a simple push of
one of our programmable buttons. The
programmable buttons store button presses and
joystick movements. The delay prior to the first
button action and after the last are not stored to
ensure that the programmed moves occur
immediately when the button is pressed, and do
not create a 'dead time' after they are
completed.
Just follow these easy steps to program your
arcade stick:
PROGRAMMING YOUR ARCADE STICK
Your Gamester Arcade Stick has been designed
with a programmable feature allowing you to
have multiple action button movements from a
single key stroke. There are two programmable
buttons, S
1 and S2, and these should be
programmed as detailed below:
IMPORTANT : The sequence of button
movements is personal to you and will be
specific to each software game. Please
spend time in getting to know this feature as
it will give you "The Unfair Advantage".
PROGRAMMING INSTRUCTIONS
1. Press Program, (Px), until the Green light
starts to flash.
2. Press the button you want to program, (S1 or
S
2), until the Green light stops flashing and is
ON.
3. Press the buttons you want to use in the
programmed sequence in the order they are
used in the game. Where a delay or gap is
required between button presses, the Back
button is used. With each press, hold the
button until the Green light flashes once.
4. Press Program, (Px), until the Green light
goes out.
Notes: a. If you want a longer button press or
longer gap then press the action
button more times to achieve this.
b. Each button press represents 1/20
second.
Use the following programming sequence as an
example:
1
2
5
4
6
9
EXPANSION SLOT
The expansion slot is an integral part of your
arcade stick and is designed to add
functionality and variety to your gaming
experience.
Expansion Slot. Supports the following
modules: 8 MB Memory Unit, 16 MB Memory
Unit and all future Xbox modules designed for
use in Slot.
JOYSTICK CHANGING
1. Remove the Hex-key from
right back of the base.
2. Insert the Hex-key into
the hole with a white
circle at the back of the
base underneath the
joystick position.
3. Hold the Hex-key and
spin the joystick
counterclockwise until it
is released from the base.
4. Select your desired
joystick.
5. Hold the Hex-key in the
hole again and screw the