Filter
Top Products
Assembling the AMT 17
Required Tools
⁵₁₆-inch hex wrench
⁵₃₂-inch hex wrench
#2 Phillips screwdriver
Rubber mallet
SAE standard socket set
Wire cutter
Torque wrench (calibrated in inch-pounds)
Performing the Assembly
DANGER
Do not attempt to connect electrical power until
all assembly procedures are complete and the
console is properly installed.
Follow these steps to assemble the AMT base unit.
To begin assembly:
1. Remove the two side fasteners that hold the front frame
tube to the shipping pallet and cut the tie wraps that
secure the rear base.
CAUTION: Do not move the AMT off its shipping pallet
without assistance. To avoid unnecessary movement of the
foot plates, do not install the handlebars until you begin the
next procedure.
2. Lift the rear base and roll the AMT forward while your
assistant stabilizes the front base and guides it off the
shipping pallet onto the floor.
Note: Begin assembly in the area intended for use.