Filter
Top Products
TO REPLACE BATTERIES
Use a Phillips/cross head screwdriver
(not included) to loosen screw
in battery compartment door as
shown (screw stays attached to
door). Remove door. Remove and
discard old batteries. Replace with 3
fresh “AA” or LR6 (1.5V) size alkaline
batteries. Replace door and tighten
screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and battery
manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to
insert item correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline
batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it
away from other electrical equipment. Reset (switching off and back on again or
removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery.
Always remove from the product before recharging. Recharge batteries under adult
supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
NOTE: Adult should remove and discard wire ties.
PLAY FEATURES
Preschoolers can pretend to build
with their new animated, electronic
buddy. Simply press the button on
the handle to make the drill “come
to life” with fun drill sounds, spinning
drill movement and silly building
phrases! Each time the button is pressed,
the PHIL THE DRILL toy will say a phrase.
You can also change the direction
in which the drill spins by moving
the two-position switch at the
top of the drill. Remember -
righty-tighty, lefty-loosey!