Filter
Top Products
120 V AC outlet
DC Input Connector
Wii AC Adapter
1. Insert the DC plug on the Wii AC Adapter cord into the DC input connector on the
back of the console.
2. Insert the AC plug into a 120V AC wall outlet. Make sure the power is off (the
Power LED is red) when unplugging the AC Adapter.
CAUTION: To prevent electric shock, match the wide blade of the plug to the
wide slot and insert fully into outlet.
Sensor Bar cable position
If desired, the Sensor Bar cable can be fed through a channel on the bottom of the
Sensor Bar to orient the cable to the left or right.
NO
NO NO
YES
Using the Sensor Bar Stand
Communication between the Wii Remote and the Sensor Bar may be improved in some situations by mounting the Sensor Bar on the Sensor Bar stand; for example, if the TV is
sitting on the floor.
Be sure to:
• Align the center of the Sensor Bar with the center of the TV.
• Align the front of the Sensor Bar with the front edge of the TV, or with the front edge of the surface that the TV is sitting on.
S y s t e m S e t u p
System Setup
System Setup
16 17
1. Remove the protective film from the foam pads
on the bottom of the Sensor Bar stand.
2. For additional stability, you can add adhesive backed foam tape from the supplied sheet. These can be applied
to both the top and bottom of the stand.
3. If you are using the extra foam tape,
remove the protective film from the
piece on the top of the Sensor Bar stand.
The Sensor Bar Stand can also be used on top of the TV if part of the TV blocks, or
prevents proper installation of, the Sensor Bar.
Make sure the Sensor Bar is horizontal
and it is not blocked by the TV.
2. Attach the Sensor Bar stand to the Sensor Bar, aligning the pegs
on the stand with the holes in the bottom of the Sensor Bar.
3. Mount the Sensor Bar stand to:
• the front edge of the surface the TV is sitting on, or
• to the top of the TV.
Do not place the Sensor Bar stand below the
surface that the TV is sitting on; for example, on
shelves below the TV.
Wii Operations Manual
148Hx210W