Kramer Electronics VP-14x1 Video Games User Manual


 
Overview
3
3 Overview
The unique VP-14xl RS-232 Port Extender distributes an incoming RS-232,
RS-485 or USB command as transmitted by a touch screen control system,
personal computer or other type of control system, to up to three RS-232 ports.
This lets you control up to three compatible devices with only one serial port or
RS-232 card.
The VP-14xl is specifically designed for use with Kramer switchers and routers,
but can be used with any other equipment which employs RS-232.
In particular, the VP-14xl features:
One RS-232 input port
One RS-485 input port
One USB input port
Three RS-232 output ports
Operation in either Hardware or Software mode
DIP-switches to determine the source of the reply command when the
VP-14xl is in hardware mode
DIP-switches to determine the machine number when operating in Software
mode and there are multiple VP-14xl units on the RS-485 bus
DIP-switches to determine the serial port baud rate (see Section
6.3)
In Hardware mode, the:
VP-14xl routes the reply from the output port defined by the DIP-switches 2,
3 and 4 (see Section
6.2)
RS-232 data is passed from any input to all outputs
In Software mode, the VP-14xl routes the data and reply based on the Protocol
2000 commands received from the PC or other device connected to any of the
inputs (RS-232, RS-485 or USB), see Section
8.
To achieve the best performance, we recommend:
Connecting only good quality connection cables, thus avoiding interference,
deterioration in signal quality due to poor matching, and elevated noise levels
(often associated with low quality cables)
Avoiding interference from neighboring electrical appliances that may
adversely influence signal quality and positioning your VP-14xl in a location
free from moisture and away from excessive sunlight and dust
!
Caution: No operator serviceable parts inside the unit
Warning:
Use only the Kramer Electronics input power wall
adapter that is provided with the unit
Warning:
Disconnect the power and unplug the unit from the wall
before installing