Fujitsu ABO22 Video Game Console User Manual


 
En-5
Fig. 5 Remote Control Unit
F SLEEP Button
G MASTER CONTROL Button
H SET TEMP./SET TIME Buttons ( )
I Signal Transmitter
J TIMER Button
K FAN CONTROL Button
L START/STOP Button
M Battery compartment lid
Inside of the battery compartment lid (Fig. 6)
N AIR FLOW DIRECTION Button
O ENERGY SAVE Button
P CODE CHANGE (Slide Switch)
Switching the remote control unit code.
(Max. 4 units)
Q TIME ADJUST Button
R TEST RUN Button
This button is used when installing the air
conditioner and should not be used under
normal conditions as it will cause the air
conditioner’s thermostat function to oper-
ate incorrectly.
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the indoor unit’s OPERA-
TION indicator light and TIMER indicator
light will begin to flash simultaneously.
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
S ACL Button
T Remote Control Unit Display (Fig. 7)
U Transmit Indicator
V Clock Display
W Operating Mode Display
X Timer Mode Display
Y Fan Speed Display
Z Temperature Set Display
[ Timer Set Indicator
\ Temperature Set Indicator
Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 OPERATION Indicator Light (red)
5 TIMER Indicator Light (green)
6 SWING Indicator Light (orange)
(VERTICAL SWING)
7 SWING Indicator Light (orange)
(HORIZONTAL SWING)
If the TIMER indicator light flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See page 17 Auto Restart).
8 Intake Grille (Fig. 3)
9 Air Filter
0 UP/DOWN Air Direction Flaps
A RIGHT/LEFT Air Direction Louvers
(behind UP/DOWN Air Direction Flaps)
B Drain Hose
Fig. 4 Outdoor Unit
C Intake Side
D Outlet Side
E Pipe Unit