Filter
Top Products
2
Setup The DMC-805G
Single Fiber Media
Converter
As with any electric device, you should
place the equipment where it will not
be subjected to extreme temperatures,
humidity, or electromagnetic
interference. Specifically, the site you
select should meet the following
requirements:
A. The ambient temperature should be
between 32 and 104 degrees
Fahrenheit (0 to 40 degrees Celsius).
B. The relative humidity should be less
than 90 percent, non-condensing.
C. Surrounding electrical devices should
not exceed the electromagnetic field
(RFC) standards for IEC 801-3, Level
2 (3V/M) field strength.
D. Make sure that the equipment receives
adequate ventilation. Do not block the
ventilation holes on each side of the
media converter or the fan exhaust
port on the side or rear of the
equipment.
E. The power outlet should be within 1.8
meters of the switch.
Connecting the power
1. This Converter is a plug-and-play
device.
2. Connect the supplied AC to DC
power adaptor with a power
voltage of 7.5Vdc/1.5Amp to the
receptacle on the rear panel of the
converter, and then attach the plug
into a standard AC outlet with a
voltage range from 100 to 260
Vac.
Sliding Switch
There is a sliding switch for duplex mode
setting for fiber port. Refer to the table
below for more details.
1
2
12
Switch 1 : On -> Forced Mode
Off -> Auto Negotiation mode
Switch 2 : On -> LLR enable
Off -> LLR disable
Installing in a
Chassis
The Converter can be fit into any
of the expansion slots on a special
designed chassis.
y First, install the converter onto a carrier
supplied with the chassis:
Step 1- Unscrew the carrier from the
desired expansion slot on the chassis.
Step 2- Remove the screw on the
converter as shown below.
Step 3- Fit the converter onto the
carrier and use the screw to secure it.
On Fiber Forced Mode
Switch 1
Off Fiber Auto-Negotiation
On LLR Enable
Switch 2
Off LLR Disable
Unscrew and pull out the media converter board