Filter
Top Products
7
2 Connect Power and Turn On the Router
CONFIG
+5V ---1.5A +/-5%
-30V--- 0.2A +/-25%
S
0
ISDN S/T
CISCO 776
ETHERNET
1
2
3
4
BRI
???
Power connector
1
4
Desktop power supply
2
3
Step 1 Connect the round end of the power
supply cable to the black circular power
connector on the rear panel of your router.
Step 2 Connect the black power supply cord to
the black power supply.
Step 3 Connect the power supply cord to an
electrical outlet.
Step 4 Turn on the router by using the on/off
switch on the rear panel.
The green RDY LED (and the NT1 LED on the
Cisco 762 and Cisco 766) on the front panel of your
router goes on. Your router is ready to be configured.
If the green RDY LED is not on, refer to the
“Troubleshooting Cisco 700 Series Routers” chapter
in the Cisco 700 Series Installation Guide, located
inside the plastic bag labeled “Open Me Only If
Needed.”