Filter
Top Products
Page 11For technical questions, please call 1-800-444-3353.SKU 69488
SAFETYOPERATIONMAINTENANCE SETUP
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the pressure washer off, unplug it from its electrical outlet, and relieve
all pressure in a safe manner before making adjustments or installing accessories.
1. MAKE SURE THE WASHER IS CLEAN AND READY FOR
USE. Ensure the inlet water strainer, nozzle, and the rest
of the Washer are completely free of buildup or debris.
2. If using the Extension Nozzle, insert it into the end of the
gun, pressing in and twisting, until it clicks into place.
If using the Soap Dispenser:
a. Remove the dispenser lid and fill with pressure
washer detergent (sold separately).
b. Set the spray to the fan setting by turning the end
of the Extension Nozzle counterclockwise.
c.
Insert the Extension Nozzle into the
Dispenser cap, pressing and twisting, until
it clicks into place (shown at right).
3. Before connecting the water supply, run water through the
garden hose (sold separately) to remove any debris.
4. Turn off the water, then thread the garden hose onto the
Water Supply Inlet on the front of the Pressure Washer.
5. Plug the Power Cord into a power outlet and test the GFCI
by pressing the Reset Button, then the Test button, then the
Reset Button again, as described in
Controls and Features section.
Note: The Pressure Washer will not work if the GFCI is not properly reset.
Reset Button
Test Button