4 Introduction
MAN0224 (Rev. 7/29/2005)
SPECIFICATIONS
3-Point Hitch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Category 1
Cutting Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1" - 9"
Blade Spindle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Number of Blades . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Blades . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Heat Treated Alloy Steel
Blade Rotation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CCW
Tractor PTO RPM. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 540
Universal Drive. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Category 3
Side Frame Thickness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Ga
Tailwheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4" x 16"
GENERAL INFORMATION
RCC42
Cutting Width 42"
Overall Width 45"
Weight (Approximate lbs.) 350 lbs.
Blade Speed (Feet per minute) 11,400
Gearbox 1:1.92
Recommended Tractor HP 15 - 30
The purpose of this manual is to assist you in operat-
ing and maintaining your cutter. Read it carefully. It
furnishes information and instructions that will help
you achieve years of dependable performance.
These instructions have been compiled from exten-
sive field experience and engineering data. Some
information may be general in nature due to unknown
and varying operating conditions. However, through
experience and these instructions, you should be able
to develop procedures suitable to your particular situ-
ation.
The illustrations and data used in this manual were
current at the time of printing but, due to possible
inline production changes, your machine may vary
slightly in detail. We reserve the right to redesign and
change the machines as may be necessary without
notification.
■ Some illustrations in this manual show the cut-
ter with safety shields removed to provide a better
view. The cutter should never be operated with
any safety shielding removed.
Throughout this manual, references are made to right
and left direction These are determined by standing
behind the equipment facing the direction of forward
travel. Blade rotation is counterclockwise as viewed
from the top of the cutter.
