Assembly 33
MAN0224 (Rev. 9/30/2005)
Figure 24. RCC42 Shipping Configuration and Assembled Unit
Figure 25. Shear Bolt Driveline Assembly
Install Slip Clutch Driveline
NOTICE
■ A grade 8 bolt must be used to attach clutch
driveline to gearbox.
NOTE: A new slip clutch, or one that has been in
storage over the winter, may seize.
1. Before operating slip clutch, make sure it will slip.
Refer to Slip Clutch Adjustment on page 18.
2. Position shield (1) against gearbox. Secure shield
to gearbox using four cap screws (2), lock washers
(3), and flat washers (4).
3. Torque hardware to 12 lbs-ft.
4. Install driveline slip clutch onto gearbox input shaft.
A. Brace arm mounting hole
B. Tailwheel pivot hole
C. PTO Hanger
D. Height adjustment bracket
E. Tailwheel assembly
2. Tailwheel bracket
3. Brace arms
4. Pivot arm
5. Pivot link & hardware
8. Mounting pin & hardware
9. Deflector plate
10. Rubber deflector
RCC42 Assembled
RCC42 Shipping Configuration
(Rev. 5/2/2008)
