Hydraulic Installation 7
MAN0041 (Rev. 4/4/2008)
HOSE KIT INSTALLATION
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety goggles.
Hydraulic fluid under pressure can easily penetrate
skin and will cause serious injury or death.
Make sure that all operating and service person-
nel know that if hydraulic fluid penetrates skin, it
must be surgically removed as soon as possible by
a doctor familiar with this form of injury or gan-
grene, serious injury, or death will result. CON-
TACT A PHYSICIAN IMMEDIATELY IF FLUID
ENTERS SKIN OR EYES. DO NOT DELAY.
Air in hydraulic systems can cause erratic oper-
ation and allows loads or equipment components
to drop unexpectedly. When connecting equipment
or hoses or performing any hydraulic maintenance,
purge any air in hydraulic system by operating all
hydraulic functions several times. Do this before
putting into service or allowing anyone to
approach the equipment.
Protective hose sleeves must cover all hydrau-
lic hoses within 20 inches of the operator and be
secured onto metal hose fittings. Replace hoses or
sleeves if damaged or if protective sleeve cannot
be properly positioned or secured.
Make sure all hydraulic hoses, fittings, and
valves are in good condition and not leaking before
starting power unit or using equipment. Check and
route hoses carefully to prevent damage. Hoses
must not be twisted, bent sharply, kinked, frayed,
pinched, or come into contact with any moving
parts. Operate moveable components through full
operational range to check clearances. Replace
any damaged hoses immediately.
58025 Hose Kit Installation - - - - - - - - - - - - - - Page 7
46945 Hose Kit Installation- - - - - - - - - - - - - - Page 11
1010460 Hose Kit Installation- - - - - - - - - - - - Page 16
1023577 Hose Kit Installation- - - - - - - - - - - - Page 19
1023584 Hose Kit Installation- - - - - - - - - - - - Page 22
1023583 Hose Kit Installation- - - - - - - - - - - - Page 24
58025 HOSE KIT
General Description
These set up instructions are for operating the 1020,
1027 loader using the tractor hydraulic remote control
levers. To use this hydraulic connection the tractor
must be equipped with either two hydraulic levers or a
joystick control and four tractor hydraulic couplers as
shown (Figure 5).
Hydraulic quick couplers for connection to tractor are
NOT INCLUDED with hose kits, but are available as
service parts.
NOTE: After the hydraulics and loader are installed
on the tractor, check the clearance between the top of
the exhaust pipe and the loader boom when the
loader is raised. If there is interference, a weather cap
will need to be installed. See Page 6 for installation
instructions.
Figure 6. Connections to Tractor Hydraulic Couplers
(Typical)
