16 Hydraulic Installation
MAN0041 (Rev. 4/4/2008)
1010460 HOSE KIT
General Description
These set-up instructions are for operating the 1020,
1027 loader using the tractor hydraulic remote control
lever. To use this hydraulic connection, the tractor
must be equipped with a multi-function hydraulic con-
trol valve and remote control lever. The control valve
is located on the right side of the tractor beneath the
operator platform.
NOTE: After the hydraulics and loader are installed
on the tractor, check the clearance between the top of
the exhaust pipe and the loader boom when the
loader is raised. If there is interference, a weather cap
will need to be installed. See Page 6 for installation
instructions.
Figure 24. Tractor Hydraulic Control Lever and Valve
Install Hydraulic Fitting to Tractor Valve
1. Locate the tractor hydraulic valve under the right
side of the tractor platform.
2. Install adapters (1), adapter (3), and female half
of quick coupler set (5) to each of the tractor valve
ports. See Figure 7 and Figure 8.
NOTE: Not all parts supplied with this hose kit are
used for this application.
1. 1010920 Adapter, M22 x 1.5 x 3/4 JICM
3. 315036 Adapter, 3/8 NPTM x 3/4 JICF
5. 316007 Quick coupler set, male & female
Figure 25. Hydraulic Fittings Installed
Figure 26. Hydraulic Fitting Installation
