Mount Installation 7
MAN0572 (Rev. 1/30/2009)
Install Grill Guard (Optional)
1. Attach grill guard (1) to the front of the tractor
using four cap screws (2) and flat washers (3).
2. Torque hardware to 244 lbs-ft.
1. 1018190 Grill guard
2. 1001377 M20 x 2.5P x 40 mm HHCS
3. 57798 3/4 Hardened flat washer
Figure 8. Grill Guard Installed
Install Oscillation Stops (Optional)
Check front tire clearance after loader has been
installed.
Using the loader, raise front of tractor off the ground
to achieve full oscillation of front axle. Turn front tires
completely to the right and left and check for tire con-
tact with loader or loader mounts. If tire contact is
present, install oscillation stops and/or adjust steering
stop bolts.
1. Attach oscillation stops (3) to right side of tractor
using cap screws (5) and hardened flat washer
(8). See Figure 9.
2. Repeat for oscillation stop installation on left side
of tractor.
3. Torque cap screws to 244 lbs-ft.
3. 1018180 Oscillation stop
5. 1001377 M20 x 2.5P x 40 mm HHCS CL10.9
8. 1006371 3/4 Hardened flat washer
Figure 9. Oscillation Stop Installed, Right Side
As a valued customer, Woods appreciates your comments. Once loader mount and
hydraulic hoses have been installed, please take a few minutes to complete the Loader
Mount Evaluation sheet that was supplied with your loader mount. Your comments will
help us continue to bring you quality products.
