Problem Possible Cause Solution
Machine Power cord not plugged in. Plug into a grounded 3prong outlet.
Stops No power at plug. Check electrical source or call
electrician.
Fuse blown or circuit Replace fuse or resetcircuit breaker.
breaker open. If problem continues, call electrician.
Using an extension cord. Do not use extension cords.
Timer is not Iined up. Turn timer to the right slightly
and pull to start.
Timer knob not pulled out. Set and pull out knob.
Machine is overloaded. Wash smaller loads.
Agitator Not The top of the agitator moves This is normal.
Working only in one direction.
The top of the agitator is loose. This is normal.
Water Level The top of the agitator is much This is normal.
Too Low/Not higherthan the highestwater
Completely Ievel.This creates a perception
Filling ofthe washer not being full,
Tub is Tub pulled forward when Ensure tub is centered before
Crooked unloading, starting washer.
Tub moves. This is normal.
Unit not level. Ensure front feet are installed and
nuts are tightened. Level washer.
Reset rear legs (see "Installation
Instructions").
Lint on Load Improper sorting. Sort lint givers from lint takers
and by color.
Overloading. Lint can be trapped in load if
overloaded.Wash smaller loads.
Paper or tissue in pockets. Clean out pocketsbefore washing,
Not enough detergent. Useenough detergent to
hold lint in water.
Detergent not dissolving. Use wash water warmer than
Water temperatures lower 70°F (21°C).
than 70°F (21°C).
27
