5.1.16 (G) DOCUMENT SIZES
This option allows you to set the active scan area for each document size (A-H). When
you choose this option, the display will be similar to figure 5-32. The actual width values
depend on the particular model. The one illustrated for A through E, for example, is for a
CF 500/44 scanner. The number of sizes that appears depends on the number of sizes set
in Global Parameters.
----- SET DOCUMENT SIZES -----
SIZE INDEX WIDTH DISPLAY STRING
------------- ----- --------------
A 2AF8 A
B 4268 B
C 5DC0 C
D 84D0 D
E A028 E
S : SET WIDTH X : EXIT CHOICE : X
Figure 5-32 Set Document Size Menu.
If you press <X>, you will be return to the Diagnostic Test menu.
If you press <S> to set new widths, the prompt: “Size Index” will appear. Enter the letter
corresponding to the document size index.
The next prompt will be “Width”. Enter the four-digit hexadecimal number of pixels. To
calculate the pixel width value, use the following formula:
W x R
Where W = the desired width in inches, and R = the scanner’s maximum resolution in pixels
per inch (or dpi). ( No <CR> is required, after the fourth character is entered the cursor will
automatically move to the next prompt.)
The final prompt is: “Display String”. Enter the four characters you wish to display on the
keypad display window. If you wish to display only one character, use the space key to center
the character. If you made a mistake, reenter to correct it. The delete and backspace keys do
not function in this option. ( No <CR> is required, after the fourth character is entered the table
is automatically updated.)
