4
User Instructions
Pivot the handle up to turn the water on, down to turn it off. Pivot the handle to the right for cooler
water, to the left for warmer water.
Install the Pop-up Drain:
Unscrew the flange from the tee. Place the tee and
sealing gasket on top of the sink. From below, install
the black mack gasket, plastic washer, and mounting
nut to the flange.
Thread the tee to the flange from beneath the sink.
The tee must be turned so that it faces the faucet.
When satisfied with the orientation, tighten the mount-
ing nut.
Sit the stopper assembly in the drain.
Install the horizontal rod so that the end goes through
the loop in the bottom of the stopper height adjuster.
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the horizon-
tal rod. Attach the swivel connector to the end of the
vertical rod. Position the vertical rod as desired, and
tighten it with a small, flat-bladed screwdriver.
Test the drain for function. If necessary, reposition the
swivel connector.
stopper assembly
height adjuster
flange
sealing gasket
mack gasket
plastic washer
mounting nut
pivot ball seal
pivot ball nut
horizontal rod
swivel connector
tee
tailpiece
