Leave the latch lock clevis pin in place at
all times while using the cart as a push cart. The clevis
pin is shown in fi gure 1 on page 4.
• To convert the cart for push operation, remove the 4"
long clevis pin and hairpin cotter which secure the
tongue in the towing position. (See drawing on page
8.) Pivot the front tongue into the storage position
underneath the rear tongue and secure it using the
same clevis pin and hairpin cotter. (See fi gure 5 on
page 5.) Place the plastic cap over the exposed end
complete regular service.
complete regular service.
MAINTENANCE/STORAGE
Check for loose fasteners X
Check for loose fasteners X
Check for loose fasteners X
Check for worn or damaged parts X
Check for worn or damaged parts X
Check for worn or damaged parts X
the maximum recommended pressure
• Check for loose fasteners before each use.
• Check for worn or damaged parts before each use.
• Keep tires fi lled to recommended tire pressure printed
• At the beginning of each season, using a light
machine oil, lubricate the latch, the latch pivot bolt,
and the area of the axle where the draw bar tongue
• Grease or oil the wheel bearings periodically (at least
once each season). Use grease or 20 weight oil. See
• Clean thoroughly before storing.
• Remove any rust from painted surfaces and coat with
• For best handling, and to help prevent accidental
tipping, distribute the weight of the load evenly in the
• Do not load more weight into the push cart than you
can handle and control comfortably.
• To dump material from the push cart, lift up on the
handle and tilt the cart forward.
mechanism on the tongue is locked and secured with
the clevis pin to prevent accidental release of the
CUSTOMER RESPONSIBILITIES
Read and follow the maintenance schedule and the procedures listed in the maintenance section.
