LOWER THREADING
Getting Ready
25
1
i
Set the bobbin holder to the left, until it
clicks into place.
a Bobbin holder (switch)
→ The bobbin starts winding automatically and stops
rotating when it is done winding. The bobbin holder
will return to the original position.
j
Cut the thread with the cutter and remove
the bobbin.
■ Using the Spool Pin
You can use the main spool pin to wind the bobbin
before sewing. You cannot use this spool pin to
wind the bobbin while sewing.
a
Turn the main power to ON and open the
top cover.
b
Align the groove in the bobbin with the
spring on the bobbin winder shaft, and set
the bobbin on the shaft.
a Groove of the bobbin
b Spring on the shaft
c
Pivot the spool pin so that it angles upward.
Set the thread spool on the spool pin so that
the thread unwinds from the front of the
spool.
a Spool pin
b Spool cap
c Thread spool
When the bobbin holder is set to the left, it
works as a switch to make the bobbin wind
automatically.
• When removing the bobbin, do not pull on
the bobbin winder seat. Doing so could
loosen or remove the bobbin winder seat,
and could result in damage to the machine.
• Setting the bobbin improperly may cause the
thread tension to loosen, breaking the needle
and possibly resulting in injury.
