A SERVICE OF

logo

BLN1-600A Chapter 3: Installation 51 of 116
Network Setup
The blender IP is the address of this blender on a network. The batch blender is factory set up
with an IP address of 192.168.0.10.
In order to change the values, enter the Setup menu, press the “Network Setup” button and
change the values accordingly. You must touch “Send Ethernet Config to Module” before
the change will take effect. After sending it to the module wait 1 minute to test
communications.
Display IP Address and Setting the Time/Date
The Set Date & Time feature is located in the “Display Config” menu of the Setup Screen.
The time is in Military Time.
The display has it’s own Ethernet port and can be configured by entering in the IP and
touching “set IP”.
Enable/Disable Modbus+ communications module
Select if Ethernet module is configured by PLC or
by a separate server.
Set IP and Subnet
Touch here to Program the Ethernet Module with
settings