BLN1-600A Chapter 4: Operation 55 of 116
Quick Start Procedure
New Recipes
1. Verify the weigh hopper calibration before running the blender (page 47)
2. Ensure that all ingredient supply hoppers to be used are filled with material. Virgin
material should be loaded into hopper #1 and regrind into hopper #3.
3. Enter the recipe menu on the touch screen by turning on the touch screen controller
(It will automatically default to this screen), and enter the blend recipe desired
following the steps listed below:
a. Touch the hopper and enter a new value (0 to 999.99), then hit the green arrow.
b. After you have entering all values push the “Accept New Recipe” icon
Existing Recipes
The operator can load a previously stored recipe from the Recipe Book. The Recipe book
also allows the operators to save the current running recipe. This can be done by performing
the following steps:
1. Touch the Recipe Book icon located on the Recipe Screen.
2. Select a stored recipe by changing the number next to “Recipe #”
3. Touch the “load recipe” icon
4. Touch the “accept new recipe” icon
To edit/save a recipe to the Recipe Book:
1. Go to the Recipe Book by touching the Recipe Book icon.
2. Select a stored recipe by changing the number next to “Recipe #”.
3. Make desired changes to the stored recipe.
4. Touch the “save” icon and wait for it to disappear.
• The blender only shows the “accept new recipe” icon if the recipe is valid.
• Recipes can also be changed while the blender is running. The new accepted
recipe is loaded at the beginning of the next batch. This allows the operator
to modify the new recipe without affecting the blender until they hit the
“Accept New Recipe” button.
