A SERVICE OF

logo

BLN1-600A Chapter 3: Installation 45 of 116
Menu Structure for Batch Blenders
Recipe Page—Start
" Change Recipe Values by
touching the number you
wish to change
" Touch “Accept New Recipe”
button after you’ve made the
desired changes
" Touch “Undo” button to
cancel a recipe change
before accepting it
" Start or stop the blender by
touching the “Push to Start or
Stop” button
" Access “Recipe Book ” Page
" Access “Clean Out” Mode
" Access “Inventory” Page”
" Access “Setup” Page
" Lock/Unlock User Interface
“Recipe Book” Page
Save the running recipe to the
book.
Create/Edit a stored recipe
Load a stored recipe
Return to the Recipe Page
“Clean Out” Mode
Empty the blender hoppers
Manually operate mixer,
weigh hopper dump gate,,
and slide gate below mixer
View/test all inputs/outputs
on the blender
Return to Recipe Page
“Inventory” Page
View/print accumulated
inventories
View batch time
View maximum capacity
View average process rate
Return to Recipe Page
Magnify “Total Inventory”
“Setup” Page
Touch the “ACS” icon and
enter in user password
Recipe Format
Percentage, Parts, or
EZ mode
Metering order
Batch size
Inventory shutdown
“Batch ready” mode
“Auto start” mode
Weigh every batch
options
Change recipe
without stopping
Report Setup
Blender number
“Auto print” option
“Auto clear” option
“Auto interval” option
Auto start time
Calibration
Scale Calibration
Direct Scale Readout
Feeder Calibration
Mixer & Dump Setup
Mixing time
Remix time
Dump time
Dump delay
Dump cycles
Mixer dump time
Time/continuous mixing
option
Continue/stop running on
Mixer Failure
Display Config
View software version
Set Time/Date
Set Red Lion IP Address
Set Screen Brightness
Units
Blender data units (lbs/kg)
Target v. actual data units
(lbs/kg)
Alarm Log
View or clear alarm log
Alarm Setup
“Stop/Continue”
when out of material
“Alarm/No Alarm”
when out of material
“Alarm Silence”
delay
Accept recipe alarm
enable/disable
Missing ingredient
compensation option
Low Levels Treated
as Alarm Only or Out
of Material
Network Setup
IP Address
Subnet Mask
Send Config to ENI
Module
Enable Ethernet
Configurator
Modbus Plus
Disabled
User Interface Lock
Lock the user interface to
prevent others from making
changes or viewing the
blender