Filter
Top Products
30
31
Using the Nunchuk
Using the Nunchuk
Using the Nunchuk
Setup and Use of the Nunchuk
Wii gameplay with the Wii Remote and Nunchuk can involve rapid or vigorous motion. Please use the wrist strap to prevent losing your grip on the remote and
causing damage to the remote and surrounding objects, or injury to other people.
Be sure to install the Nunchuk as described. Use the connector hook on the Nunchuk plug with the wrist strap cord or connector cover cord to prevent the
Nunchuk plug from becoming separated from the External Extension connector on the remote or Wii MotionPlus accessory and striking objects or people.
2. Pass the connector cover cord
through the connector hook on the
back of the connector.
Connecting the Nunchuk to the Wii MotionPlus accessory
1. Remove the connector cover from
the bottom of Wii MotionPlus. Grasp
the cover by the sides as shown.
Insert the connector plug into the
External Extension Connector on the
bottom of the remote until it “clicks”
into place.
3. Insert the tab on the edge of the
connector cover into the connector
hook. Press the connector cover
firmly into place on the connector plug.
4. Place your hand through the wrist
strap and adjust the strap lock so
that the strap will not fall off your
wrist. Do not over tighten the strap
lock so that it’s uncomfortable. It
should just be tight enough to hold
the wrist strap in place.
Close the lever (if your strap lock
has one) until it clicks to hold the
strap lock in place.
Connector cover
CAUTION - Use the Wrist Strap
Connector hook
Disconnecting the Nunchuk
Follow these procedures to remove the Nunchuk, Classic Controller, or other
accessories that you have connected to Wii MotionPlus.
1. Remove the connector cover from
the accessory connector plug.
Be sure to pull the connector cover
straight out of the connector hook
to prevent damage to the tab on
the edge of the cover.
Holding the Nunchuk and Wii Remote
2. Press the lock release levers on the
sides of the accessory connector
plug and pull the plug straight out
of the connector.
3. Remove the connector cover cord
from the accessory plug’s
connector hook.
4. Insert the connector cover into the
External Extension Connector on
the bottom of Wii MotionPlus.
Wii Operations Manual
148Hx210W