Filter
Top Products
Bosch Security Systems | 2007-02 | 9922 141 70691 en
DCN Wireless | Installation and User Instructions | Central Devices en | 68
7 Push the microphone button of each wireless device.
When the central control unit gives a subscription to
the wireless discussion unit, the LED around the
microphone button comes on as green for 2 s.
12.2.3 Extra DCN devices
You can also give addresses to active devices in the
DCN after you did the initialization of the system.
• Push the de-init switch of the active DCN device for
less than half a second to erase the address of the
active device.
• Push and hold the de-init switch of the active DCN
device for more than one second to erase the address
and do the initialization at the same time.
12.2.4 Extra wireless devices
You can also give subscriptions to wireless device after
you did the initialization of the system. Refer to 14.6 for
instructions.
12.3 Wireless modes
12.3.1 Introduction
You can set the wireless mode of the system with the
4A Wireless Mode menu item.
12.3.2 On
If the wireless mode is On, the wireless network is
activated. The delegates and chairman can use the
wireless devices that:
• Have a subscription, and
• Are activated.
12.3.3 Sleep
If the wireless mode is Sleep, the wireless network is in
the sleep mode. Use the sleep mode to increase the time
between charge of the batteries (for example, during a
long break in a discussion or conference).
12.3.4 Off
If you set the wireless mode to Off, the wireless network
is deactivated. All wireless devices with a subscription
are automatically deactivated.
12.3.5 Subscription mode
If the wireless mode is Subscription, the wireless
network is in the subscription mode. Use the
subscription mode to give subscription to extra wireless
devices (refer to 12.2.4).
Note
The wireless devices are not deactivated in the
sleep mode.
Note
The central control unit automatically goes back
to the previous wireless mode 15 minutes after
the last wireless device got a subscription.