TROUBLESHOOTING GUIDE
v
o
l
u
m
e
b
a
s
s
t
r
e
b
l
e
ANCHOR Audio, Inc. (310) 784-2300
100-0126-000 / Rev. A - 08/03
Having trouble with the sound system?
Condition Possible Solution
No sound (power LED not lit): • turn POWER switch on
• plug in power cord
No sound (power LED lights): • check for output from source
• make sure all cables are completely plugged in
• increase volume control
• press mute button on remote (AN-130RC only)
• turn power switch to off then back to on
(AN-130RC only)
Distorted sound: • check input cable connection
• lower input signal level
Excessive hum or noise: • use shielded input cable
Having trouble with the wireless system?
Condition Possible Solution
No sound: • confirm transmitter power switch is set to on
• turn up volume control
• plug microphone into body-pack transmitter
• turn sound system on
• replace mic/transmitter battery
• make sure collar, headband or lapel mic cable is
fully plugged into transmitter
• turn off mute by pressing, volume up,
volume down or mute (AN-130RC only)
Frequent transmitter dropouts: • replace mic/transmitter battery
• move mic/transmitter closer to AN-130
• change transmitter to different channel
AN-130
AN-130DC
AN-130RC
AN-130U1
Owner’s Manual